Inland Crossing

Tag Archive: WJ

K&N Air Filter

I’ve been using K&N air filters since the early eighties on my vehicles, and have found them to be a good value based on their re-useability, if not for their claims of superior filtration. While shopping for an air filter…
Read more

Winch Isolator

When I first installed the synthetic rope onto the drum and wound it up on the bench I noticed that the hook didn’t exactly snugly mate against the hawse fairlead. Unable to tension it any further, the hook kind of…
Read more

Cabling Up the Winch

The last tasks in setting up the winch and making it functional are to hook it up to the battery and to re-spool the winch rope under some tension. When I originally installed the rope it was on the bench,…
Read more

ARB Bumper Installation

In previous posts I’ve outlined the preparation of the ARB bumper – from sanding and painting to winch setup. This post caps the series by describing the installation on the WJ. The instructions from ARB are fairly complete. The descriptions…
Read more

Winch Setup Part 1 – Clocking the Winch

Setting up this winch will be a bit different than others I have done. All my others have been on top of the bumper and integrated solenoids. Because this one is integrated into the bumper, I’ll have to do some…
Read more

ARB Bumper Prep 4 – Installing Marker Lights

In part 1 of the bumper prep I located replacement marker lights for the ARB Bull Bar. The old lights were corroded and the lenses were warped from the heat of the bulbs. Installation of the new lights was straightforward…
Read more